User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Update the firmware
Yamaha LAN Monitor for Mac User Guide
40
Update the firmware
LAN Monitor allows you to update the firmware in the following two ways.
• Update the firmware one by one (page 40) from the “Device Settings” dialog (page 36)
• From the “Firmware Update” tab (page 33) on the list screen, select “Update firmware on multiple units at once”
(page 42)
NOTE
• Since L2MS is used for firmware updates, it is easy to update the firmware even without an IP address configured.
• For devices that do not support firmware update from LAN Monitor, you can use the Web GUI (page 39) to update the
firmware.
Update the firmware one by one
To update the firmware, follow the steps below.
1. Use one of the following methods to display the “Device Settings” dialog for the device that
supports firmware update.
• “Device Settings” button on the Map screen
• “Switch / Wireless AP List” tab on the List screen - “Setting” button