User Manual

[Example]
Set the LLDP transmission/reception mode of LAN port #1 to receive-only.
SWX3220(config)#lldp run
SWX3220(config)#interface port1.1
SWX3220(config-if)#lldp-agent
SWX3220(lldp-agent)#set lldp enable rxonly
4.23.7 Set type of management address
[Syntax]
set management-address-tlv type
no set management-address-tlv
[Parameter]
type : Type of management address
Setting value Description
ip-address Set IP address as the management address
mac-address Set MAC address as the management address
[Initial value]
set management-address-tlv ip-address
[Input mode]
LLDP agent mode
[Description]
Sets the type of port management address used by LLDP.
If this command is executed with the "no" syntax, the setting returns to the default.
The specified value is set in "LLDP Management Address TLV".
[Example]
Set the MAC address as the type of management address for LAN port #1.
SWX3220(config)#lldp run
SWX3220(config)#interface port1.1
SWX3220(config-if)#lldp-agent
SWX3220(lldp-agent)#set management-address mac-address
4.23.8 Set basic management TLVs
[Syntax]
tlv-select basic-mgmt
no tlv-select basic-mgmt
[Initial value]
none
[Input mode]
LLDP agent mode
[Description]
Adds basic management TLVs to transmitted frames.
If this command is executed with the "no" syntax, exclude basic management TLVs from transmitted frames.
This command adds the following TLVs to LLDP frames.
<Basic management TLV>
(1) Port Description TLV : Description of port
(2) System Name TLV : Name of system
(3) System Description TLV : Description of system
(4) System Capabilities TLV : System capabilities
114 | Command Reference | Maintenance and operation functions