User Manual

4.23.15 Set multiplier for calculating time to live (TTL) of device information
[Syntax]
set msg-tx-hold value
no set msg-tx-hold
[Parameter]
value : <1-100>
Multiplier for calculating the time to live (TTL) value of device information
[Initial value]
set msg-tx-hold 4
[Input mode]
LLDP agent mode
[Description]
Sets the multiplier for calculating the time to live (TTL) of device information.
If this command is executed with the "no" syntax, the setting returns to the default.
This setting is multiplied with the LLDP frame transmission interval (msg-tx-interval), and then increased by +1 to become the
TTL value (seconds).
The TTL value is set in "Time To Live TLV".
TTL = msg-tx-interval x msg-tx-hold + 1 (seconds)
[Example]
Set 2 as the multiplier used to calculate the time to live (TTL) for device information on LAN port #1.
SWX3220(config)#lldp run
SWX3220(config)#interface port1.1
SWX3220(config-if)#lldp-agent
SWX3220(lldp-agent)#set msg-tx-hold 2
4.23.16 Set number of LLDP frames transmitted during the high speed transmission period
[Syntax]
set tx-fast-init value
no set tx-fast-init
[Parameter]
value : <1-8>
Number of LLDP frames transmitted during the high speed transmission period
[Initial value]
set tx-fast-init 4
[Input mode]
LLDP agent mode
[Description]
Sets the number of LLDP frames transmitted during the high speed transmission period.
If this command is executed with the "no" syntax, the setting returns to the default.
[Example]
Set 2 as the number of LLDP frames transmitted during the high speed transmission period on LAN port #1.
SWX3220(config)#lldp run
SWX3220(config)#interface port1.1
SWX3220(config-if)#lldp-agent
SWX3220(lldp-agent)#set tx-fast-init 2
118 | Command Reference | Maintenance and operation functions