User Manual

Partner LAG 0x8000, 00-a0-de-11-11-11
Partner Key 0001
Link count 0/ 1
Link
port1.2 Selected Synchronized no
port1.3 Unselected Synchronized no
Aggregator po127
ID 4727
Status Ready
Actor LAG 0x8000, 00-a0-de-e0-e0-e0
Admin Key 0127
Partner LAG 0x8000, 00-a0-de-11-11-11
Partner Key 0001
Link count 0/ 1
Link
port1.4 Selected Synchronized no
5.2.13 Set LACP port priority order
[Syntax]
lacp port-priority priority
no lacp port-priority
[Parameter]
priority : <1-65535>
LACP port priority order
Lower numbers have higher priority
[Initial value]
lacp port-priority 32768
[Input mode]
interface mode
[Description]
Sets the LACP port priority order.
If this command is executed with the "no" syntax, the setting returns to the default value.
[Note]
If up to eight LAN/SFP ports are combined into an LACP logical interface, they are immediately combined into the LACP
logical interface; ports in excess of eight are standby ports used in case of a malfunction.
In such cases, the priority order between the LAN/SFP ports are evaluated, and they are combined starting with the
highestpriority port.
The priority order is evaluated as follows.
1 ) Priority is given to ports with a lower LACP port priority.
2 ) If the LACP port priority is the same, priority is given to the lower interface number.
If an SFP port is to be given priority, its LACP port priority must be set lower than other ports.
[Example]
Set the LACP port priority order to 1024.
SWX3220(config-if)#channel-group 1 mode active
SWX3220(config-if)#lacp port-priority 1024
5.3 Port authentication
5.3.1 Configuring the IEEE 802.1X authentication function for the entire system
[Syntax]
aaa authentication dot1x
no aaa authentication dot1x
Command Reference | Interface control | 183