User Manual

Policy-Map Name: policy1
State: attached
Class-Map Name: class1
Qos-Access-List Name: 1
Police: Mode: SrTCM
average rate (48 Kbits/sec)
burst size (12 KBytes)
excess burst size (12 KBytes)
yellow-action (Remark [DSCP:10])
red-action (Drop)
9.2.40 Show map status
[Syntax]
show qos map-status type [name]
[Parameter]
type : Type of map to show
Setting value Description
policy Show policy map status information
class Show class map status information
name : The name of the policy map (or class map) to show. If this is omitted, all policy maps (or class maps)
[Input mode]
unprivileged EXEC mode, privileged EXEC mode
[Description]
Shows policy map or class map status information.
By using this command, you can obtain information about the combination of policy maps or class maps, such as the LAN/SFP
ports and logical interfaces to which a policy map is applied, or the policy maps to which a class map is registered.
The following content is displayed.
policy-map
Item Display information
input port List of LAN/SFP ports and logical interfaces to which the
policy map is applied
edit/erase Whether policy-map/no policy-map can be executed
attach limitation Whether attachment is possible for each trust mode
class-map
Item Display information
policy-map asociation List of policy maps to which the class map is associated
edit/erase Whether class-map/no class-map can be executed
attach limitation Whether attachment is possible for each trust mode
Use the show policy-map and show class-map commands to check the settings of the policy map or class map.
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Show the status of policy map "policy1".
SWX3220#show qos map-status policy policy1
policy1 status
input port : port1.3
edit/erase : Disable
Command Reference | Traffic control | 437