User Manual

[Parameter]
src_config_num : Copy source configuration number
Setting value Description
<0-1> Configuration #0-#1
sd Configuration on the SD card
dst_config_num : Copy destination configuration number
Setting value Description
<0-1> Configuration #0-#1
sd Configuration on the SD card
[Input mode]
privileged EXEC mode
[Description]
This copies the entire set of data in connection with the local RADIUS server.
• Route certificate authority
• Client certificates issued
• User data
• Management file
When you need to copy all settings including the command settings, you can use the copy startup-config command to copy.
[Note]
If an SD card that is not mounted is specified, an error will occur.
[Example]
This copies the config #0 RADIUS data to the SD card.
SWX3220#copy radius-server local 0 sd
Succeeded to copy Radius configuration
10.4.16 Show RADIUS client (NAS) status
[Syntax]
show radius-server local nas host
[Parameter]
host : IP address or IP network address
Setting value Description
IPv4 address (A.B.C.D)
Range from 0.0.0.1 to 223.255.255.255, except
for 127.0.0.1
IPv4 network address (A.B.C.D/M)
The network mask range is from 8 to 32, and the
IP address host part will be “0”
IPv6 address (A:B:C::D)
Out of all unicast addresses, the exceptions are
unspecified addresses (::/128), default root
addresses (::/0) and loopback addresses (::1/128)
IPv6 network address (A:B:C::D/M) The prefix length is 1–128
[Input mode]
privileged EXEC mode
[Description]
Shows a list of RADIUS clients (NAS).
Command Reference | Application | 473