Service manual

6-11
E
LOWR
INSPECTION
15500-0
CLUTCH DOG AND COMPONENTS
1. Visually inspect the clutch dog, looking
particularly for rounding of the dog
edge, cracks and other signs of damage
or wear. If the dog is excessively
rounded, inspect the mating gear, and
replace both if necessary.
156000-0
DRIVE AND PROPELLER SHAFT
1. Visually inspect the shafts, looking for
grooved wear on the surface in contact
with the bearings and oil-seals and
checking for wear on the splines.
Replace if worn or damaged.
156300-0
DRIVE SHAFT SLEEVE
1. Visually inspect the sleeve for wear and
cracks. If any damage is found, replace
the sleeve.
157000-0*
PROPELLER/TRIM TAB/ANODE
1. Refer to “PERIODIC SERVICE” section in
chapter 3.