Service manual

7-10
E
BRKT
BRACKET UNIT
Trim sensor adjustment
Fully tilt up the outboard motor.
Loosen the two bolts securing the trim sen-
sor until it moves slightly.
WARNING
Be sure to support the engine with the tilt
support lever while loosening the bolts to
prevent the engine from tilting down due
to lack of oil pressure.
Fully tilt down the outboard motor.
Connect battery cables of the outboard
motor to a battery and set the main switch
to “ON”.
Adjust the trim sensor position by pushing
a screw driver so that one segment on the
trim indicator on the digital meter goes on.
Tilt up the outboard motor and tighten both
installation bolts.
WARNING
Be sure to support the engine with the tilt
support lever while tightening the bolts to
prevent the engine from tilting down due
to lack of oil pressure.
ASSEMBLY
1. Referring to the exploded diagram,
assemble the bracket unit.