Service manual

8-21

–+

ELEC

ELECTRICAL ANALYSIS

M55000-0

STARTER RELAY

1. Check for continuity between the termi-

nals and the ends of the black and

brown leads.

2. Test to ensure there is no continuity

between terminals.

3. Check the relay operation.

1) Connect a tester between the termi-

nals of the starter relay. Connect the

leads of the starter-relay to a 12-V

battery.

B : Black

Br : Brown

4. Check that there is continuity between

the starter relay terminals. If the opera-

tion is not as specified, replace the

starter relay.

Brown lead........................................ (+)

Black lead.......................................... (–)

Battery voltage:

12V

M51410-0

POWER TRIM AND TILT RELAY

1. Check the relay for terminal looseness

and for wiring rust and corrosion.

Replace the relay if any of the three

defects is found.

2. Connect the (+) terminal and 1 terminal

and the (+) terminal and 2 terminal to

the tester and check that the resistance

becomes ∞ in each case.