Service manual

4-16
ENG
CYLINDER HEAD
a
b
c
d
8. Check:
9
“I”mark
a
Align the “I” mark on the generator rotor
with the stationary pointer
b
on the
crankcase.
9
“I”mark
c
Align the “I”mark on the camshaft sprocket
with the stationary pointer
d
on the cylinder
head.
Out of alignment
→
Correct.
Refer to the installation steps above.
9. Measure:
9
valve clearance
Out of specification
→
Adjust.
Refer to “ADJUSTING THE VALVE CLEAR-
ANCE” in chapter 3.
10. Install:
9
O-rings
9
water pump assembly
9
water pump assembly bolts
11. Install:
9
spark plug
12. Install:
9
intake manifold bolts
9
intake manifold with carburetor
10 Nm (1.0 m•kg, 7.2 ft•lb)
13 Nm (1.3 m•kg, 9.5 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
http://mototh.com