Service manual

GEN
INFO
CHECKING THE CONNECTIONS
1
EAS00026
CHECKING THE CONNECTIONS
Check the leads, couplers, and connectors for
stains, rust, moisture, etc.
1. Disconnect:
9
lead
9
coupler
9
connector
2. Check:
9
lead
9
coupler
9
connector
Moisture
→
Dry with compressed air.
Rust/stains
→
Connect and disconnect
several times.
3. Check:
9
all connections
Loose connection
→
Connect properly.
NOTE:
If the pin
1
on the terminal is flattened, bend it
up.
4. Connect:
9
lead
9
coupler
9
connector
NOTE:
Make sure all connections are tight.
5. Check:
9
continuity
(with the pocket tester)
NOTE:
8
If there is no continuity, clean the terminals.
8
When checking the wire harness, perform
steps (1) to (3).
8
As a quick remedy, use a contact revitalizer
available at most part stores.
1-4
Pocket tester
90890-03112
http://mototh.com