Service manual

ELEC
8-7
CHECKING THE BULBS AND BULB SOCKETS
EAS00732
CHECKING THE BULBS AND
BULB SOCKETS
Check each bulb and bulb socket for damage or
wear, proper connections, and also for continu-
ity between the terminals.
Damage/wear
→
Repair or replace the
bulb, bulb socket or both.
Improperly connected
→
Properly connect.
No continuity
→
Repair or replace the bulb,
bulb socket or both.
TYPES OF BULBS
The bulbs used on this vehicle are shown in the
illustration on the left.
9
Bulbs
A
and
B
are used for the headlights
and usually use a bulb holder that must be
detached before removing the bulb. The major-
ity of these types of bulbs can be removed
from their respective socket by turning them
counterclockwise.
9
Bulb
C
is used for turn signal and tail/brake
lights and can be removed from the socket by
pushing and turning the bulb counterclockwise.
9
Bulbs
D
and
E
are used for meter and indica-
tor lights and can be removed from their
respective sockets by carefully pulling them
out.
A
B
C
D
E
http://mototh.com