Service manual

ELEC
8-32
SIGNALING SYSTEM
NOTE:
9
Before troubleshooting, remove the following
part(s):
1. side cowling (right)
2. front cowling
3. center panel (lower)
4. rear cowling (right)
5. headlight assembly
9
Troubleshoot with the following special tool(s).
EAS00794
TROUBLESHOOTING
Check:
1. fuse
2. battery
3. main switch
4. wiring connections
(of the entire signaling system)
EAS00738
1. Fuse
9
Check the fuse for continuity.
Refer to “CHECKING THE FUSE” in chapter
3.
9
Is the fuse OK?
YES NO
Replace the fuse.
EAS00739
2. Battery
9
Check the condition of the battery.
Refer to “CHECKING AND CHARGING THE
BATTERY” in chapter 3.
9
Is the battery OK?
YES NO
9
Clean the battery
terminals.
9
Recharge or
replace the bat-
tery.
Pocket tester
90890-03112
Minimum open-circuit voltage
12.8 V or more at 20 ° C (68 ° F)
99
Any of the following fail to light: turn sig-
nal light, brake light or an indicator light.
99
The horn fails to sound.
Replace the main
switch.
EAS00783
3. Main switch
9
Check the main switch for continuity.
Refer to “CHECKING THE SWITCHES”.
9
Is the main switch OK?
YES NO
EAS00795
4. Wiring
9
Check the entire signaling system wiring.
Refer to “CIRCUITDIAGRAM”.
9
Is the signaling system wiring properly con-
nected and without defects?
YES NO
Properly connect or
repair the signaling
system wiring.
Check the condi-
tion of each of the
signaling system
circuits.
Refer to “CHECK-
ING THE SIGNAL-
ING SYSTEM”.
http://mototh.com