User Manual

Table Of Contents

Toolbar

Reference Manual

TF series

BUS SETUP screen

Allows you to configure bus settings. You can change basic settings such as stereo/mono, Pan

Link, etc. These settings are included when saving a Scene.

1 AUX1/2–AUX7/8 signal type selection button

MATRIX1/2–MATRIX3/4 signal type selection button (V3.5 and later)

Determines how each pair of buses is processed. You can set each pair to be either

Stereo (an odd and even numbered bus are paired and main parameters are shared

between the two) or MONO x2 (two independent mono channels).

2 Pre Fader Send Point selection button

Selects the send point when Pre is on, for the send from the input channel to the AUX

bus.

Pre EQ: directly before EQ

Pre Fader: directly before fader

3 AUX1/2–AUX7/8 Pan Link buttons

Turns pan link on and off for AUX1/2–AUX7/8.

These buttons are only displayed if the Signal Type of the corresponding bus is set to

Stereo. When these buttons are turned on, the pan setting of signals sent from input

channels to the corresponding two buses will link with the Stereo bus pan setting.

4 AUX9/10–AUX19/20 Pan Link buttons

Turns pan link on and off for AUX9/10–AUX19/20.

5 STEREO/SUB Level Link

When turned on, the levels of the STEREO channel and the SUB channel are linked.

For V3.0 and later, when turned on, the gain for both channels can be adjusted together

but the difference in gain between the two channels is maintained.

Additionally, for TF5/TF3/TF1, you can adjust the difference in gain between the two

channels by adjusting the faders while pressing the [SEL] key on the panel.

ձղ