User Manual

Configuration screens
Reference Manual
TF series
- 58 -
4 Level meter
Displays the gain adjusted level.
5 Digital gain text box
Allows you to adjust the digital gain. It is set to 0 dB by default. You can touch the text
box to highlight it, then use the [TOUCH AND TURN] knob to adjust the setting. You
can also touch the text box again to adjust the setting using the keyboard screen.
6 Φ (phase) button
Allows you to reverse the phase.
When turned on, the input signal's phase is reversed.
7 Gain slider
When the INPUT button is selected, the slider adjusts the analog gain of the head amp.
The PAD (-24 dB) will be switched on or off when the analog gain is adjusted between
+17 dB and +18 dB.
When the USB button is selected, the slider adjusts digital gain.
8 +48V button
Turns phantom power (+48 V) to the head amp on and off.
On: Phantom power is turned on.
Off: Phantom power is turned off.
When the USB button is selected, the +48V button is not displayed.
9 Gain Unlink button (V1.1 and later)
Displayed for stereo channels and for channels that have stereo link turned on.
While you are touching the button, gain for the left and right channels can temporarily
be adjusted individually. When you release the button, the gain for both channels can
be adjusted together but the difference in gain between the two channels is maintained.
NOTICE
Information about phantom power
When phantom power is not needed, set the +48V button to the off position.
Observe the following when using phantom power to prevent damage to the console or connected
devices, and signal noise.
• Do not set the +48V button to the on position when the device connected to the input jack does
not require phantom power.
• Do not connect or disconnect cables when the +48V button is set to the on position.
• Before turning phantom power on or off for a channel, first set the channel's volume to the
minimum level.
NOTE
When using phantom power, noise may be generated if there is a difference in the impedance between
the hot and cold of the device connected to an input jack.
Setting stereo link and the input source
1. Display the INPUT screen. (page 5)
2. Touch the stereo link selection button that
corresponds to the desired setting.
3. Touch the input selection button that
corresponds to the desired setting.
4. Use the gain slider to adjust the
head amp gain.
Adjust the gain slider so that the center of
the GainFinder lights up.
5. Touch the digital gain text box to highlight
it, then use the [TOUCH AND TURN] knob to
adjust the setting.
Gain finder level display
Gain slider
Digital gain
text boxes