User Manual

Configuration screens
Reference Manual
TF series
- 60 -
5 EQ mode type selection button
When using 1-knob EQ mode, allows you to select the 1-knob EQ mode type. Select
[Vocal] for vocal channels, otherwise select [Intensity].
When set to [Intensity], you can adjust the EQ to a setting between flat and double the
intensity of the EQ settings you made using manual mode.
For output channels, [Loudness] is available. This setting allows you to boost low and
high tones.
The available types depend on the channel whose settings you are editing.
In manual mode, this button switches the filter type. Low-band and high-band filter are
available.
For CH 1-40, the available low-band filters are low-shelving type and bell type.
For other channels (i.e., for channels that do not have an HPF), the available low-band
filters are HPF, low-shelving type, and bell type.
The available high-band filters are LPF, high-shelving type, and bell type.
6 EQ output level meter
Displays the post-EQ level.
7 EQ graph
Displays the parameter settings of the EQ and filter. As you adjust the settings of each
band, the results are reflected in the graph.
When using 1-knob EQ mode, you can touch the level slider and then adjust the slider
using the slider itself or the [TOUCH AND TURN] knob.
When using manual mode, you can drag the handles displayed in the graph to adjust
the corresponding settings.
When HPF is turned on, you can drag the HPF handle to adjust the cutoff frequency. You
can also adjust HPF independently when using the Intensity type for 1-knob EQ mode.
<1-knob EQ mode> <Manual mode>
How does 1-knob EQ mode work?
1-knob EQ mode allows you to adjust several parameters at once with just the turn of a knob.
It makes EQ adjustment quick and easy.
The console contains Presets that are configured for a variety of instruments. You can use 1-
knob EQ mode to adjust the EQ settings that are saved in Presets without disturbing the
overall balance of your mix.
You can even configure EQ settings using manual mode, then switch to 1-knob EQ mode and
use the Intensity type to adjust the amount of EQ applied to the channel. In this case you can
use the [TOUCH AND TURN ] knob to adjust from 0% (no EQ applied) to 50% (the EQ
settings you made using manual mode) and 100% (double the intensity of the EQ settings you
made using manual mode). This makes it very easy to fine-tune your EQ settings with just one
knob.
If 1-knob EQ mode type is set to Vocal or Loudness, you can adjust the EQ between 0% (no
EQ applied) and 100% (maximum EQ applied).
Type
Channel
CH1-32
HPF +
4-band
CH33-40
HPF +
2-band
ST IN
2-band
FX
2-band
STEREO
4-band
AUX1-8
4-band
AUX9/10–
AUX19/20
4-band
MATRIX
1-4
4-band
SUB
2-band
+ LPF
Intensity
○○○○○○ ○ ○
×
Vocal
○
××××× × ××
Loudness × × × ×
○○ ○ ○
×