User Manual

Configuration screens
Reference Manual
TF series
- 73 -
SEND TO AUX screen
Allows you to configure the amount of signal that is sent from each channel to the AUX buses.
You can swipe left and right to view other buses.
1 Send button
Determines whether a signal is sent (on) or not sent (off) to the corresponding AUX bus.
2 Send level slider
Determines the amount of signal sent to the corresponding AUX bus.
3 Pre button
Selects whether to send the signal to the AUX channel from before the fader, or from
after the fader.
On: Before fader
Off: After fader
When this is on, you can select whether to send the signal directly before the EQ or
directly before the fader, from "Pre Fader Send Point" on the BUS SETUP screen
(page 33).
4 Send pan slider
Displayed for stereo AUX buses. Allows you to adjust the pan of the signal sent to the
corresponding AUX bus.
ձ
ղ
ճ
մ
Adjusting the SEND TO AUX level
1. Adjust the level sliders as desired.
Each level slider determines the amount of signal sent from
the selected channel to the corresponding AUX bus.
2. Turn the Pre button on or off depending on your
needs.
Send the pre-fader signal when using the AUX bus for on-stage floor monitors—this allows you to
create a mix that is separate from the main mix.
Send the post-fader signal when using external effects processors or when you want to maintain the
same mix balance as the main mix.
3. Turn the send button on or off.
When turned on, the signal is sent to the corresponding AUX
bus.
4. Touch the send pan slider and then adjust it using the [TOUCH AND TURN] knob.
When sending the signal to a stereo AUX bus, you can adjust the pan of the signal that is sent.