User Manual

Configuration screens
Reference Manual
TF series
- 77 -
C Direct out port indicator
Indicates the channel's direct out port.
For information about channels and output ports, see "Quick Config Input and input
channel relationships" (page 106).
D Direct out point button
Allows you to set the point of the direct out signal.
Pre DG: Before the digital gain
Pre HPF: Before the high-pass filter
Pre Fader: Before the fader
Post ON: directly after the [ON] key; CH1–CH8 are directly after the AUTOMIXER
E Direct out on/off button
Turns the direct out on and off.
CH33–CH40
1 Channel name
Touch to display the CH NAME screen.
Touch to display information for a different channel.
2 Recall Safe button
Turns recall safe on and off for the corresponding channel.
You can display the RECALL SAFE screen (page 38) by touching the jump button in
the right corner of the Recall Safe button.
3 Input source indicator
Displays the input channel's input source. You can select the input source on the INPUT
screen.
4 Mute Safe button
Touch to temporarily exclude the selected channel from the input mute group.
If you mute the input mute group, any channels in that group that have mute safe
enabled will not be muted.
5 Boxes
Touch to display the configuration screen for the corresponding feature.
You can touch the EQ button displayed here to turn EQ on and off.
HA box: Displays the INPUT screen. (page 57)
EQ box: Displays the EQ screen. (page 59)
6 Channel on/off button
Turns the selected channel on and off.
7 PAN slider
Adjusts the pan for the selected channel.
8 FX1/FX2 boxes
Displays the effect type.
When selected, you can use the [TOUCH AND TURN] knob to adjust the effects send
level. You can also display the corresponding effect's configuration screen by touching
again.
Each box displays the amount of signal from the selected channel that is sent to the
corresponding effects module.
Send level, the selected channel's fader level, and the actual send level grouped with the
DCA is displayed in the triangular bar.
Displays whether the signal sent to the FX1/2 return channel is from directly before the
fader, or directly after the fader. If the indicator lights green, the signal is directly before
(pre-fader); and if the indicator is off, the signal is directly after (post-fader).
9 SEND TO AUX box
Touch when selected to display the SEND TO AUX screen.
Displays the amount of signal from the selected channel that is sent to each AUX bus.
Send level, the selected channel's fader level, and the actual send level grouped with the
DCA is displayed in the horizontal bar.
ձղմ նշո
չ
պ
ջռյճ