User Manual

Toolbar

User’s Guide

TF Editor

0 Delay setting

Allows you to set the unit of measure for the delay: frames, meters, feet or ms (milliseconds).

Click a text box to enter a value.

A Monitor source selection buttons

Allow you to select the sources that will be monitored.

TF5/TF3/TF1

TF-RACK

OSCILLATOR screen

Allows you to configure the oscillator.

1 Oscillator mode button

Allows you to select the oscillator mode.

SINE WAVE: A sine wave will be output continuously.

PINK NOISE: Pink noise will be output continuously.

BURST NOISE: Pink noise will be output intermittently.

2 Parameter sliders

Allows you to adjust parameters for the oscillator.

3 Oscillator output button

Turns the oscillator output on and off. When the oscillator is turned on, the oscillator signal is sent to the input channels that

are selected by the oscillator assignment buttons.

4 Oscillator output level slider

Adjusts the oscillator output level.

5 Oscillator output meter

Displays the oscillator output level.

6 Oscillator assignment buttons

Determine which channels the oscillator is sent to. You can click this button to select multiple channels.

Oscillator mode Available parameters

SINE WAVE Frequency

BURST NOISE Width (duration of each noise burst) and Interval (length of silence between noise bursts)

PINK NOISE None

ձղճ

յն