User Manual

Toolbar

User’s Guide

TF Editor

BUS SETUP screen

Allows you to configure bus settings. You can change basic settings such as stereo/mono, Pan Link, etc.

These settings are included when saving a Scene.

1 AUX1/2–AUX7/8 signal type selection button

MATRIX1/2–MATRIX3/4 signal type selection button

Determines how each pair of buses is processed. You can set each pair to be either Stereo (an odd and even numbered bus

are paired and main parameters are shared between the two) or Mono x2 (two independent mono channels).

2 Pre Fader Send Point selection button

Selects the send point when Pre is on, for the send from the input channel to the AUX bus.

Pre EQ: directly before EQ

Pre Fader: directly before fader

3 AUX 1/2–AUX 7/8 Pan Link buttons

Turns pan link on and off for AUX 1/2–AUX 7/8.

These buttons are only displayed if the Signal Type of the corresponding bus is set to Stereo.

When these buttons are turned on, the pan setting of signals sent from input channels to the corresponding two buses will

link with the Stereo bus pan setting.

4 AUX 9/10–AUX 19/20 Pan Link buttons

Turns pan link on and off for AUX 9/10–AUX 19/20.

5 STEREO/SUB Level Link

Determines whether the faders for the STEREO bus and the SUB bus are linked.

ձղ