User Manual

Main display area
User’s Guide
TF Editor
- 48 -
EQ screen
Controls the EQ for each channel.
4-band parametric EQ is available for CH 1–32, AUX 1–19/20, STEREO, and MATRIX 1–4. 2-band parametric EQ is available for
CH 33–40, ST IN 1, ST IN 2, FX1, FX2, and SUB.
You can adjust settings using 1-knob mode, which allows you to use the mouse wheel to easily adjust settings, or manual mode,
which allows you to adjust each parameter individually.
4-band parametric EQ
1 EQ button
Turns the EQ on and off.
2 HPF button
Turns the HPF (high-pass filter) on and off.
Displayed for CH 1–40.
3 1-knob button
Switches between 1-knob mode and manual mode.
When using 1-knob mode, the 1-knob level slider is displayed.
4 1-knob level slider
Adjusts the amount of 1-knob EQ applied.
When using manual mode, information about the selected band's Q, F, and G is displayed here.
5 EQ mode type selection button
When using 1-knob mode, allows you to select the 1-knob EQ mode type.
Select [Vocal] for vocal channels, otherwise select [Intensity].
When set to [Intensity], you can adjust the EQ to a setting between flat and increased intensity of the EQ settings you made
using manual mode.
For output channels, [Loudness] is available. This setting allows you to boost low and high tones.
The available modes depend on the channel whose settings you are editing.
In manual mode, you can select the filter type. You can select low-band and high-band filter.
For CH 1–40, the available low-band filters are low-shelving type and bell type.
For other channels (i.e., for channels that do not have an HPF), the available low-band filters are HPF, low-shelving type, and bell type.
The available high-band filters are LPF, high-shelving type, and bell type.
Type
Channel
CH 1–32
HPF +
4-band
CH 33–40
HPF +
2-band
ST IN
2-band
FX
2-band
STEREO
4-band
AUX 1–8
4-band
AUX9/10–
AUX19/20
4-band
MATRIX1–4
4-band
SUB
2-band
+ LPF
Intensity
○○○○○○○○
×
Vocal
○
×
×××××××
Loudness
×××
×
○○○○
×
ձղ ճ մ յ
ն
շ
ո