User Manual
Reference
User’s Guide
TF Editor
-
89
-
Reference
Error messages
Message Description
Item Already Exists. Replace it? You tried to overwrite an item in the Library.
File Already Exists, Replace it?
When using Save As, the name of the file you tried to save was the same name as an existing file.
When using Save. you tried to overwrite an existing file.
Operation Failed! An error occurred during the operation. (This is a general error.)
Invalid Name! Name violates naming convention.
Operation Ignored. The feature assigned to the USER DEFINED KNOB could not be operated when the message was displayed.
SCENE #XX is Empty! No data is stored in the Scene you tried to recall, or the data is damaged.
SCENE #XX is Read Only! You tried to overwrite a Scene that is write-protected.
Cannot Store! Could not save the data in the Scene memory or in the library.
Cannot Recall! Could not recall the data from the Scene memory or from the library.
LIBRARY is Read Only! You tried to overwrite data in the library that is write-protected.
Operation Failed. Library Memory Full. You tried to add data when the memory was full.
Turn Off 1-knob Mode to Adjust. 1-knob mode is enabled; turn 1-knob mode off.
Nothing to Paste! You tried to paste data when the copy buffer was empty.
Page does not exist. The page does not exist.
Cannot Close This Popup. The popup could not be closed.
Unsupported File Format! You tried to read an unsupported file format.
Couldn't Write File. The file could not be saved.
File Protected! Could not overwrite the file because the file is write-protected.
Already Exists! The name of the directory you tried to create or edit matches the name of an existing directory.
Couldn't Access File. Could not access the file for some reason.
File Error! An internal file access error occurred.
Illegal IP Address! The IP address setting or gateway setting is incorrect.
Wrong Word Clock! (Slot) Could not sync to the console because the NY64-D sample rate setting is incorrect.
Wrong Word Clock! (Dante Device)
Could not sync to the NY64-D because the sample rate of the device connected to the Dante network that is
connected to the console via the NY64-D is incorrect.
USB Sample Rate Mismatch on USB.
Console:44100Hz
The sample rates of the console and the computer that is connected via the USB TO HOST connector do not
match. (Console: 44.1 kHz, Computer: 48 kHz) Set the computer's sample rate to 44.1 kHz.
USB Sample Rate Mismatch on USB.
Console:48000Hz
The sample rates of the console and the computer that is connected via the USB TO HOST connector do not
match. (Console: 48 kHz, Computer: 44.1 kHz) Set the computer's sample rate to 48 kHz.