English Deutsch Français Tio1608-D Italiano Português Español I/O RACK Owner’s Manual Русский Bedienungsanleitung Mode d’emploi EN DE Manual do Proprietário FR Manuale di istruzioni PT Руководство пользователя 取扱説明書 ES IT RU JA AUDIO INTERFACE 日本語 Manual de instrucciones
The above warning is located on the rear of the unit. L’avertissement ci-dessus est situé sur l’arrière de l’unité. Explanation of Graphical Symbols Explication des symboles The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions.
Tio1608-D Owner’s Manual -4-
Table of contents Included items ........................................................ 5 PRECAUTIONS ...................................... 6 Introduction ........................................ 8 Main features .......................................................... Updating the firmware ............................................ Dante support......................................................... Precautions when rackmounting............................. Recessed Installation ..................
PA_en_5 1/2 PRECAUTIONS Hearing loss PLEASE READ CAREFULLY BEFORE PROCEEDING • When turning on the AC power in your audio system, always turn on the power amplifier LAST, to avoid hearing loss and speaker damage. When turning the power off, the power amplifier should be turned off FIRST for the same reason. Please keep this manual in a safe place for future reference. Fire warning • Do not place any burning items or open flames near the device, since they may cause a fire.
Connections • Before connecting the device to other devices, turn off the power for all devices. Also, before turning the power of all devices on or off, make sure that all volume levels are set to the minimum. Failing to do so may result in electric shock, hearing loss, or equipment damage. NOTICE To avoid the possibility of malfunction/ damage to the product, damage to data, or damage to other property, follow the notices below.
Introduction Introduction Thank you for purchasing the Yamaha Tio1608-D I/O rack. The Tio1608-D is an I/O rack that features 16 channels of analog inputs and 8 channels of analog outputs. In order to take full advantage of this product's features, and to enjoy years of trouble-free use, please read this document before you begin using the product. After you have read this document, please keep it in a safe place.
Device features Front panel ղ ձ մ յ ն շ ոչ պ ջ ռճ 1 [INPUT] jacks 1–16 Combination jacks that support both XLR and TRS phone connectors. Use these jacks to connect mics and instruments. Nominal input level is -62 dBu to +10 dBu. When connecting a cable that uses an XLR plug, make sure you supply +48 V phantom power to any devices that require it.
Device features 8 [SYSTEM] indicators Indicate the status of the Tio1608-D. During normal operation, the green indicator is lit and the red indicator is off. When the unit is turned on, if the green indicator is off and the red indicator is lit or is flashing, an error has occurred. 9 [SYNC] indicators Indicate the status of the unit's internal Dante clock sync. When the green indicator is lit, the unit is the clock slave, and the clock is in sync.
Device features ձ ղ 1 AC IN connector ճ յ ն English Rear panel մ 3 DIP switches Connect the included power cord. When connecting to a power outlet, first connect the power cord to the unit, then connect the power cord to the power outlet. Caution Make sure the unit is turned off before connecting or disconnecting the power cord. 2 [FAN] switch Allows you to set the unit's internal cooling fan to run at high or low speed.
Device features Switch position NOTE If switches 7 and 8 are set to the "update mode" or "diagnostic mode" positions, the unit will not be reset. 7 8 • Switch 4 (Dante SECONDARY port mode) This switch determines the operating mode of the [SECONDARY] Dante connector. Switch position 4 4 Start up mode Diagnostic mode When Quick Config is used, the "normal operation" mode settings are disabled.
Connection methods This section explains the different methods for connecting the Tio1608-D to other Dante devices. 4. Use Ethernet cables to connect the Tio1608-D to the NY64-D card (installed in the TF series mixing console) or to other Tio1608-D units in a daisychain configuration, as shown below. Quick Config (automatic setup) When using Quick Config, the units will operate the same whether you connect the Ethernet cables to the [PRIMARY] or [SECONDARY] Dante connector.
Connection methods 7. To assign the Tio1608-D inputs to the TF series mixing console, set the input select on the console's INPUT screen to "SLOT". Manual setup You can configure your devices manually if you do not want to use Quick Config. Tio1608-D procedure 1. With the unit turned off, set the [QUICK CONFIG] switch on the front panel to the [OFF] position. 2. Refer to the information on page 11 - 12 and set the DIP switches to the desired positions. 3.
Troubleshooting Troubleshooting Issue No power, power indicator does not light Unit is not receiving an input signal Cause Solution Power cord not connected. Make sure the power cord is connected (page 11). The [POWER] switch is turned off. Set the [POWER] switch to the "on" position. If you still cannot resolve the problem, please contact your nearest Yamaha representative. Cables not connected properly. Make sure all cables are connected properly.
How to read the indicators How to read the indicators You can use the [SYSTEM] and [SYNC] indicators to confirm the unit's status. The indicators can relay operational status, error status, and warnings. Error status If one of the following errors has occurred, the device will not operate. Until the error is resolved, the green SYSTEM indicator will be turned off, and all indicators for all I/O channels will continue to flash.
How to read the indicators English Warnings The indicators will light and/or flash as shown until the cause is resolved. If the green [SYNC] indicator is unlit, the unit’s clock is unconfirmed. [SYNC] Indicators Off Off Off Description Possible Solution Clock settings are incorrect. Check the clock master and sampling frequency settings of the Tio1608-D and Dante Controller. Unit not connected to Dante network. Make sure the cables are not damaged and that they are connected properly.
Tio1608-D Bedienungsanleitung - 18 -
Specifications Specifications English General Specifications Output impedance of signal generator: 150ohms Measured with another Tio1608-D through Dante network. Frequency Response Typ. Max. Unit -1.5 0.0 0.5 dB Conditions 600Ω +4dBu@20Hz-20kHz, GAIN: +66dB. Min. Typ. Max. Unit 0.1 600Ω +4dBu@20Hz-20kHz, GAIN: -6dB. % 0.05 % Max.
Specifications Input Output Digital I/O Character Analog input characteristics Input Terminals INPUT1-16 GAIN +66dB Actual Load For Use With Impedance Nominal 7.5kΩ Input Level *1 Sensitivity 50-600Ω Mics or 600Ω Lines -6dB Nominal Max. before clip -82dBu (61.6μV) -62dBu (0.616mV) -42dBu (6.16mV) -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V) balanced / Unbalanced Connector Balanced Combo Jack (XLR-3-31 type*2 or TRS phone*3) In these specifications, 0dBu = 0.775Vrms.
Specifications English Dimensions 7.
ADDRESS LIST NETHERLANDS/BELGIUM/ LUXEMBOURG NORTH AMERICA CANADA Yamaha Music Europe Branch Benelux Clarissenhof 5b, 4133 AB Vianen, The Netherlands Tel: +31-347-358040 Yamaha Canada Music Ltd. 135 Milner Avenue, Toronto, Ontario, M1S 3R1, Canada Tel: +1-416-298-1311 FRANCE U.S.A. Yamaha Corporation of America 6600 Orangethorpe Avenue, Buena Park, CA 90620, U.S.A. Tel: +1-714-522-9011 CENTRAL & SOUTH AMERICA MEXICO Yamaha de México, S.A. de C.V. Av. Insurgentes Sur 1647 Piso 9, Col.
Yamaha Pro Audio global website http://www.yamahaproaudio.com/ Yamaha Downloads http://download.yamaha.
