User Manual

Configuration screens

Reference Manual

TF series

SEND FROM screen menu

Press the Menu key ( ) from the SEND FROM screen to display the following options.

Adjusting the send level from AUX channels, STEREO channels, and SUB

channel to a MATRIX channel (V2.5 and later)

1. Touch the ON button for the AUX channel, STEREO channel, or SUB channel that

you want to send. (It is turned on by default.)

2. Drag the send level sliders to adjust the amount of AUX channel, STEREO channel,

and SUB channel signal that is sent.

3. When a MATRIX channel is set to "Stereo", the PAN slider can be used to pan the

sound. (V3.5 and later)

ON button

Send level slider

PAN slider

NOTE

• You can send the post-on signal of an AUX channel, STEREO channel, or SUB channel to a MATRIX

channel.

• Left and right channel SEND levels can be adjusted independently for stereo channels such as AUX 9/

10 and STEREO.

• When a MATRIX channel is set to "Stereo", the PAN slider becomes a BAL (balance) slider for the

stereo channel (V3.5 and later).

• To switch between "Stereo" and "MONOx2" for a MATRIX channel, use the settings on the BUS SETUP

screen, located in the SETUP screen. (page 33)

1 All Pre

Turns on all Pre buttons.

2 All Post

Turns off all Pre buttons.

3 All Nominal (V2.0 and later)

Sets all SEND levels to nominal (0 dB).

4 Dup. STEREO (V2.0 and later)

Duplicate STEREO. Copies each channel's fader

level and applies it to the SEND level.

5 Copy (V4.0 and later)

Copies the SEND level for the selected AUX/

MATRIX channel.

6 Paste (V4.0 and later)

Pastes the SEND level you copied to the selected

AUX/MATRIX channel.