User Guide

ManualsBrandsYamaha ManualsOtherTG500E2

VCE,PFM

＜Ｒch ＞

MULTI

＜each ch＞

MIDI

VCE,PFM

MULTI

VCE,PFM

MULTI

VCE,PFM

MULTI

Program Change

＜Ｒch ＞

＜each ch＞

＜Ｒch ＞

＜each ch＞

＜Ｒch ＞

＜each ch＞

＜Ｒch ＞

＜each ch＞

＜Ｒch ＞

＜each ch＞

VCE,PFM

＜Ｒch ＞

MULTI

＜each ch＞

$Bn,$20

$Bn,$00 BANK SELECT

I, C, and P are switched.

$Cn PROGRAM CHANGE

I, C, and P are not switched

$Dn AFTER TOUCH

$En PITCH BENDER

$FE ACTIVE SENSING

$8n NOTE OFF

$Bn,$00 controllers

↓↓

$Bn,$78 ↓

$9n NOTE ON/OFF

$An POLY AFTER TOUCH

MULTI

VCE,PFM

MULTI

PLAY MODE

VCE,PFM

Poly AT FLT

Control chg.

FLT

1.Synthesizer mode

1. MIDI reception/transmission block diagram

<MIDI reception conditions> 1/2

Ｒch ---- Voice Receive ch.

Voice bulk

Performance bulk

Multi bulk

Synth setup bulk

Sample bulk

Sample dump standard

Parameter change

Sample Dump Request

2. Channel message

2.1 Reception

2.1.1 Note Off

Reception note range = C-2...G8

Velocity range = Not received

2.1.2 Note On/Off

Reception note range = C-2...G8

Velocity range = 0...127

2.1.3 Polyphonic After Touch

Polyphonic After Touch is received when it is set to on during

system setup.

Reception note range = E0...G6

If the received note exceeds the above range, the effect is applied

to the maximum and minimum note values.

2.1.4 Control change

The parameters in the table below can be controlled by MIDI.

* Pan is received only when MULTI is generated.

cntrl parameter data rng

 10 Pan* 0 ∼ 127

 16 Effect Control 1 0 ∼ 127

 17 Effect Control 2 0 ∼ 127

 18 MIDI Control 3 0 ∼ 127

 19 MIDI Control 4 0 ∼ 127

0 ∼ 119 Volume 0 ∼ 127

0 ∼ 120 MIDI Control 1 0 ∼ 127

0 ∼ 120 MIDI Control 2 0 ∼ 127

0 ∼ 120 MIDI Control 3 (add) 0 ∼ 127

0 ∼ 120 MIDI Control 4 (add) 0 ∼ 127

0 ∼ 120 Effect Control 1 (add) 0 ∼ 127

0 ∼ 120 Effect Control 2 (add) 0 ∼ 127

 64 Sustain Switch 0, 127

<MIDI reception conditions> 2/2

$F0,$43,$10,$29,$08,$00

SW REMOTE

$F0,$43,$0n,$7A NORMAL VOICE bulk

(LM__0065VC)

$F0,$43,$0n,$7A DRUM VOICE bulk

(LM__0065DR)

$F0,$43,$0n,$7A PERFORMANCE bulk

(LM__0065PF)

$F0,$43,$0n,$7A SONG(MULTI) bulk

(LM__0065MU)

$F0,$43,$0n,$7A SYNTH SETUP bulk

(LM__0066SY)

$F0,$43,$0n,$7A Sample bulk(SY99)

(LM__0040SA)

Sample Dump Standard

$F0,$7E,$cc,$01 Dump Header

$F0,$7E,$cc,$02 Data Packet

$F0,$43,$1n,$29,$xx Parameter change

MIDI

$F0,$43,$1n,$04,$40 Parameter change

(Master Tuning)



$F0,$43,$2n,$7A VOICE bulk D.req.

(LM__0065VC)

$F0,$43,$2n,$7A

PERFORMANCE bulk D.req.

(LM__0065PF)

$F0,$43,$2n,$7A MULTI bulk D.req.

(LM__0065MU)

$F0,$43,$2n,$7A Synth Setup bulk D.req.

(LM__0066SY)

$F0,$43,$2n,$7A 1 Sample bulk D.req.

(LM__0040SA)

Dev No = Device Number

Bulk Protect

off

≠off

＜Dev No＞

Sample Dump Standard

$F0,$7E,$cc,$03 Dump Request

$F0,$7E,$cc,$7C Wait

$F0,$7E,$cc,$7D Cancel

$F0,$7E,$cc,$7E NAK

$F0,$7E,$cc,$7F ACK

＜Dev No＞

≠off

MIDI

TG500

MIDI DATA FORMAT

Summary of content (8 pages)

PAGE 1
TG500 MIDI DATA FORMAT 1. Synthesizer mode 1/2 Ｒch ---- Voice Receive ch. $FE ACTIVE SENSING Parameter change $8n NOTE OFF Sample Dump Request MIDI ＜Dev No＞ Voice bulk Performance bulk Multi bulk Synth setup bulk Sample bulk Sample dump standard 1. MIDI reception/transmission block diagram ≠off VCE,PFM ＜Ｒch ＞＜each ch＞ $9n NOTE ON/OFF MULTI VCE,PFM ＜Ｒch ＞ Poly AT FLT $An POLY AFTER TOUCH ＜each ch＞ MULTI Control chg. FLT 2.
PAGE 2
.1.5 Program change 2.1.6 Pitch bend Pitch bend is received only on the MSB side. When a program change is received, the TG500 performs the following operations. Three reception mode types can be set during the system setup. 2.1.7 After touch After touch is received in accordance with the reception channel of each mode. 1) off : Program change is not received. 2) normal : In each play mode, the program No. changes in accordance with 00∼63 of the current mode . The program bank change is not received.
PAGE 3
(2) Data Format Name (4) Operation (Transmission) When the data is edited with the panel switch, the parameter change is transmitted in accordance with the previously stated transmission conditions. Bulk Dump Type Normal Voice Drum Voice Performance Multi(Song) Synthesizer Setup Sample (Reception) 1)∼4) The TG500 has three sound generation modes: Voice, Performance and Multi. Only when the sound generation mode of the transmitting side and receiving side match, Reception is possible.
PAGE 4
＜ Table 1 ＞ (1) MIDI Parameter Change table ( Multi ) $F0,$43,$1n,$29,$00,sub_group,p_msb,p_lsb,v_msb,v_lsb,$F7 Note) n ; Device Number s ; parameter sub_group number p ; parameter number v ; parameter value [MULTI PARAMETERS] 1. COMMON s=0 PARAMETER BULK NUMBER PARAM NUMBER DATA RANGE DISP reserved 0 ― 0 effect mode 1 1 0..2 off,seri,para effect1 type 2 2 0..90 0..90 effect2 type 3 3 0..90 0..90 effect control1 parameter effect control1 add controller 4 5 4 5 0..31 0..124 off.
PAGE 5
PARAMETER 2. INST BULK NUMBER PARAM NUMBER DATA RANGE DISP effect insert 2b 72 40 0..100 0..100 multi name top 73 49 32..127 ASCII multi name | 74 50 32..127 ASCII multi name | 75 51 32..127 ASCII multi name | 76 52 32..127 ASCII multi name | 77 53 32..127 ASCII multi name | 78 54 32..127 ASCII multi name | 79 55 32..127 ASCII multi name bottom 80 56 32..
PAGE 6
PARAMETER BULK NUMBER PARAM NUMBER DATA RANGE DISP 204..213 214..223 224..233 234..243 244..253 (2) MIDI Parameter Change table ( Performance ) $F0,$43,$1n,$29,$01,sub_group,p_msb,p_lsb,v_msb,v_lsb,$F7 Note) n ; Device Number s ; parameter sub group number p ; parameter number v ; parameter value 1. COMMON s=0 PARAMETER BULK NUMBER PARAM NUMBER DATA RANGE DISP reserved 0 ― 0 effect mode 1 1 0..2 off,seri,par effect1 type effect2 type 2 3 2 3 0..90 0..90 0..90 0..
PAGE 7
PARAMETER 2. LAYER BULK NUMBER PARAM NUMBER DATA RANGE DISP effect lfo wave 67 35 0..6 tri..1tm effect lfo speed 68 36 0..99 0..99 effect lfo delay time 69 37 0..99 0..99 effect insert 1b 70 38 0..100 0..100 effect insert 2a 71 39 0..100 0..100 effect insert 2b 72 40 0..100 0..100 performance name top 73 49 32..127 ASCII performance name | 74 50 32..127 ASCII performance name | 75 51 32..127 ASCII performance name | performance name | 76 77 52 53 32..
PAGE 8
PARAMETER BULK NUMBER PARAM NUMBER DATA RANGE DISP layer LFO depth 118,119 22 0..255 -99..+99 layer AT use 120,121 23 b0,1,2 off,use a,b,c,d reserved b3 0 layer MIDI Control1 use b4,5,6 off,use a,b,c,d reserved b7 0 layer MIDI Control2 use b0,1,2 off,use a,b,c,d reserved b3 0 layer PEG switch b4 off/on layer sustain switch b5 off/on 0..127 C-2..G8 b7 normal/fix fixed mode note# 122,123 124,125 24 25 frequency fix switch reserved 126 0 127..169 170..212 213..