User Manual

•
[OUT PATCH] button
If this is on, the output patch settings and output channel names will be recalled.
•
[OUT PORT] button
If this is on, the output port’s output gain and polarity settings will be recalled.
•
[EXT. I/O YDIF] button
If this is on, settings for the audio that is output from the MTX to YDIF when in Distribution mode will be
recalled.
•
[DCP] button
If this is on, the parameter assignments of the DCP (digital control panel) unit connected to the MTX/MRX
will be recalled. The button shows the ID of the DCP.
•
[MY4-AEC] button (MTX5-D only）
If this is on, the settings of the MY4-AEC installed in the MTX5-D will be recalled.
The following settings are outside the recall settings of the [MY4-AEC] button.
◦
From Far-end, Far-end Voice, Near-end Mic., Near-end Voice, and To Far-end (included in the [IN
PATCH] button range)
◦
SRC
14. Audio Processors : MTX5-D/MTX3
ProVisionaire Design User Guide | 207