User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
106
Sending the Speech Privacy environmental sound
Before going online, send the environmental sound to be used for Speech Privacy to the MRX.
1.
Start up the MRX Designer.
2.
Select [Install Speech Privacy File] from the [File] menu.
The “Install Speech Privacy File” dialog box will appear.
If “Installed” is displayed in the “File” field, the environmental sound has already been installed in the MRX, so there
is no need to send it.
3.
Select the checkbox in the “Install” field, and click the [Install] button.
A dialog box will appear, indicating that this may take a while. Click the [Yes] button to continue.
4.
When “Complete” is displayed in the “File” field, close the dialog box.