User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
108
Verifying that the settings were applied
The main items to verify are listed below. For details on each parameter setting, refer to “MTX-MRX Editor User Guide”
and “MRX Designer User Guide.”
1.
Input an audio signal such as AUX IN to the inputs of the MRX7-D, and adjust the input lev-
els.
Adjust the AUX IN input levels using “Fader(2).” You can use ProVisionaire Touch to adjust the level of sound com-
ing from the room speakers.
2.
Adjust the Speech Privacy output level using “Fader(7).”
3.
Adjust the input level of the mic using the “ANALOG IN” editor.
Turn the [+48V] button on as necessary.
4.
Adjust the other inputs and outputs.
5.
Confirm the settings on the ProVisionaire Touch.
Check whether the ProVisionaire Touch is operating according to the settings.
When you have finished making all settings, save the project and switch MTX-MRX Editor offline.
This completes the settings for example 2.
NOTICE
Be sure to leave this button off if you do not need phantom power.
Follow the important precautions below, in order to prevent noise and possible damage to external devices as well as the
unit when you operate this switch.
• Be sure to leave this button off when you connect a device that does not support phantom power to [INPUT] connector.
• Do not connect/disconnect a cable to/from [INPUT] connector while this button is on.
• Down the output level to the minimum before operating this button.
NOTE
There is no master switch. To avoid malfunctions, be sure to set this appropriately for the equipment that is connected.