User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
117
Set the DIP switches of the DCP units as directed in “Digital Control Panel” of the cabling diagram.
For the last DCP (ID=6), set DIP switch 4 upward.
If you want to use the Device Configuration Wizard to change the device configuration, click the [Device Config] but-
ton in the Project screen.
Specifying the MRX configuration
Use MRX Designer to specify the internal configuration of the MRX.
When you’ve finished making settings, you should save them by clicking [File] menu, then [Save].
Starting MRX Designer
Move to the setting screen by clicking the tab of the system name you specified in step 1 of “Using the Device Config-
uration Wizard to create your device setup.”
After you’ve moved to this screen, click the “Open MRX Designer” button to start MRX Designer.
NOTE
If you want to view the cabling diagram again, choose [File] menu → [Print Configuration Diagram].
Placing and connecting the components
NOTE
The “User Account Control” dialog box may appear. Click [Continue] or [Yes].
1
ON
2 3 4