User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
162
In this example, we’ll do various things to make the best use of the MCP1’s switches, such as combining two faders of a
stereo output into a single fader, and combining the L/R ON buttons into a single button.
We’ll create parameter link groups that combine multiple level-type or on/off-type parameters, so that a switch of the
MCP1 can control multiple parameters simultaneously.
As for a snapshot, you can register parameters by holding down <Ctrl> while you drag and drop, but since there are a total
of 24 parameters to be registered for this example, we’ll use a different method to register them.
1.
In the left side of MRX Designer, open the “Parameter Link Group” area.
This is opened in order to check the parameters that have been registered.
Setting a parameter link group