User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
164
4.
Click [Ch03:Level]; then hold down <Ctrl> and click [Ch04:Level].
By clicking while you hold down <Ctrl>, you can select multiple items.
To select multiple adjacent parameters, click the first parameter, then hold down <Shift> and click the last parameter.
5.
Right-click, and choose [Add to Parameter Link Group] → [Add New Group].
A dialog box opens, allowing you to specify a parameter link group name.
6.
Enter [Spin Area BGM LEVEL], and click the [OK] button.
In the “Parameter Link Group” area, a [Spin Area BGM LEVEL] group is created, and the Link Master editor opens.