User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
176
Here you’ll assign parameters to the MCP1 units located in Studio and Spin Area, so that parameters can be controlled by
switches.
We’ll assign the following parameters to the switches of the home page. The method of making Source Selector and Fader
assignments is essentially the same as for the DCP. The methods for assigning parameter link groups and designing the
screen are described later.
Each L3 switch is used to adjust the mic level.
We’ll explain how to design Studio A’s R3 switch (parameter link group) and screen.
Making MCP1 settings
Area Switch Component that includes the parameter to be assigned Parameter
Studio A
L1
Studio A’s Source Selector
1
L2 3
L3 Source Mix (Studio A) Fader (2) Channel 1 level
R1
Studio A’s Source Selector
2
R2 4
R3 Parameter link group’s Studio A BGM LEVEL Link master level
Studio B
L1
Studio B’s Source Selector
1
L2 3
L3 Source Mix (Studio B) Fader (3) Channel 1 level
R1
Studio B’s Source Selector
2
R2 4
R3 Parameter link group’s Studio B BGM LEVEL Link master level
Spin Area
L1
Spin Area’s Source Selector
1
L2 3
L3 Source Mix (Spin Area) Fader (4) Channel 1 level
R1
Spin Area’s Source Selector
2
R2 4
R3 Parameter link group’s Spin Area BGM LEVEL Link master level