User Manual

MRX Setup Manual 2
The MRX Setup Manual explains how to create setups using the MRX and MTX-MRX Editor.
As examples, we will provide simple explanations of the typical setups described below.
For detailed parameter settings, refer to “MTX-MRX Editor User Guide” and “MRX Designer User Guide”.
When you install MTX-MRX Editor, the three example files described here will be found in the following folders.
 32-bit operating system
C:\Program Files\Yamaha\MTX-MRX Editor\V*.*\ProjectFile
 64-bit operating system
C:\Program Files(x86)\Yamaha\MTX-MRX Editor\V*.*\ProjectFile
*.* will be the version of the installed MTX-MRX Editor.
Example 1 : MRX7-D Ballroom-*.mtx
Example 2 : MRX7-D Conference-*.mtx
Example 3 : MRX7-D+PGM1+MCP1 Fitness-*.mtx
-* is a management number. In some cases, there will be no -*.
Example 1) Ballroom where the Room Combiner can be used
This is an example where the sections of the room can be split or combined, as in a ballroom.
This example assumes that you’re using the following equipment.
The number of speakers is not specified; choose amplifiers that are suitable for your speaker setup. You will also
need to provide the appropriate number of cables.
Introduction
Wireless
Microphone Receiver
AUX IN
Room A
Rack
Microphone
Ch=1
Microphone
Ch=2
Microphone
Ch=3
Microphone
Ch=4
Microphone
Ch=5
Microphone
Ch=6
DCP ID=0 DCP ID=1 DCP ID=2 DCP ID=3
Room B
Rack
AUX IN
•MRX7-D × 1
• MY8-ADDA96 × 1
• DCP4V4S × 2
• DCP4S × 2
• Amplifier
(two channels of amplification)
• Speakers (the number needed)
• SD memory card × 1
• Background music source such as a Blu-ray
player × 2
• Stereo input ports such as an AUX IN × 2
• Wireless microphone receivers (6 channels)
• Wireless microphones × 6