User Manual

Example 3) A paging system using the PGM1
MRX Setup Manual
201
Verifying that the settings were applied
The main items to verify are listed below. For details on each parameter’s settings, refer to “MTX-MRX Editor User’s
Guide” and “MRX Designer User’s Guide.”
1.
In “Output Ch.” User Defined Block, set “Speaker Processor” to a value appropriate for the
speaker.
2.
Input audio signals from the analog inputs and stereo inputs into the MRX7-D, and adjust
the input levels.
To check the input levels, you can use the “Fader” component editor and the “Fader” component editor within the
“Source Mix” User Defined Block.
3.
Adjust the EQ using the “PEQ” located inside the “Output Ch.” User Defined Block.
Since the Studio and Spin Area use mics, make adjustments while inputting sound to the mics.
4.
While inputting sound to the mic, adjust the parameters of the components in the “Input
Ch. Strip” User Defined Block.
5.
Operate the PGM1 to verify that paging broadcast occurs correctly.
6.
Operate the DCP and MCP1 units to verify that they work correctly.
When you have finished making all settings, save the project and switch MTX-MRX Editor offline.
This completes the settings for example 3.