User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 1) Ballroom where the Room Combiner can be used
MRX Setup Manual
23
4.
Change the name of the User Defined Block that you pasted to “Room B”, by using
[Label] in the “Properties” area.
Connecting to the input components
The input components are connected to other components as shown below.
Input
components
Port
number
Port
name
Destination
component/
block
Port
number
ANALOG IN
1 Mic A1 Room A 1
2 Mic A2 Room A 2
3 Mic A3 Room A 3
4 Mic B1 Room B 1
5 Mic B2 Room B 2
6 Mic B3 Room B 3
8 Paging PEQ(10) 1
MY8-
ADDA96(IN)
1 AUX AL Room A 6
2 AUX AR Room A 7
3 AUX BL Room B 6
4 AUX BR Room B 7
5BGM 1PEQ(6) 1
6BGM 2PEQ(7) 1
7BGM 3PEQ(8) 1
8BGM4PEQ(9) 1
STEREO IN
1 BD AL Room A 4
2 BD AR Room A 5
3 BD BL Room B 4
4 BD BR Room B 5