User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 1) Ballroom where the Room Combiner can be used
MRX Setup Manual
33
In this example, we’ll operate a DCP switch to switch between split and combined rooms. Although you can simply recall
the presets for split rooms and for combined rooms respectively, you can make quicker changes to the settings just by turn-
ing the Combine button in the “Room Combiner plus Automixer” editor on and off, rather than recalling all of the parame-
ters.
Now, we’ll explain how to create a snapshot.
1.
Open the “Parameter Sets” area on the left side of the MRX Designer.
2.
Click the [New] button.
A dialog box for setting the parameter set name will appear.
Specifying snapshots
Step 2