User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
MRX Setup Manual 5
The following table shows the workflow for connecting equipment such as MTX series signal processors and XMV series
power amplifiers to your computer, and making settings in MTX-MRX Editor.
For details on PGM1 settings, refer to page 142.
Installing MTX-MRX Editor
In order to connect MRX series devices to your computer, you’ll need to download MTX-MRX Editor from the “down-
load” page of the Yamaha Pro Audio website.
http://www.yamahaproaudio.com/
System Requirements
Example 1 Example 2 Example 3
Installing MTX-MRX Editor Page 5
Starting up MTX-MRX Editor Page 6
Using the Device Configuration Wizard to create your device setup Page 7 Page 65 Page 110
Configuring the settings on
the MRX
Placing and connecting the components Page 13 Page 71 Page 117
Compiling Page 32 Page 88 Page 161
Specifying snapshots Page 33 — —
Setting a parameter link group Page 38 Page 89 Page 162
Making the DCP settings Page 42 — Page 166
Making MCP1 settings — — Page 176
Creating the Remote Control Setup List
used by ProVisionaire Touch
— Page 93 —
Storing presets Page 53 Page 97 Page 185
Making EXT. I/O settings — Page 99 Page 190
Connecting the equipment Page 61 Page 104 Page 198
Powering-on the MRX Page 62 Page 105 —
Powering-on the amp Page 62 Page 105 —
Specifying the computer’s TCP/IP address Page 62 Page 105 Page 199
Sending the Speech Privacy environmental sound — Page 106 —
Taking MTX-MRX Editor online Page 63 Page 107 Page 200
Verifying that the settings were applied Page 64 Page 108 Page 201
OS Windows 10 (32bit/64bit)
CPU Core i3/i5 or better
Memory 4 GB or more
H.D.D. 230 MB or more free (When you install, need 480 MB or more free.)
Other Bonjour must be installed, Ethernet (1000BASE-T or higher)
NOTE
The System Requirements described above are applied to the MTX-MRX Editor version 4.0.0. You can check the latest version infor-
mation of each program and its system requirements at the following website
http://www.yamahaproaudio.com/
The system requirements may differ slightly depending on the particular computer.
Setup workflow