User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 1) Ballroom where the Room Combiner can be used
MRX Setup Manual
61
Connecting the equipment
After you’ve rack-mounted the MRX and your other equipment, connect the MRX and the other equipment as shown
below. If you’ve copied audio sources to an SD memory card, insert the card into the MRX now.
Room B
Room A
DCP
ID=3
DCP
ID=2
DCP
ID=1
DCP
ID=0
BD Player
Microphone
A3
Microphone
A2
Microphone
A1
Microphone
B3
Microphone
B2
Microphone
B1
Computer
MRX7-D
BGM Player
Room B
AUX IN
Room A
AUX IN
Paging
Power Amp
Room A Room B