User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
77
4.
Connect the space between “STEREO IN” output ports 1/2 to the “Matrix Mixer” input
ports 1/2 by dragging and dropping.
5.
Connect the space between “STEREO IN” output port 3 to the “Matrix Mixer” input port
3 by dragging and dropping.
6.
Connect the space between “Matrix Mixer” output ports 2/3 to “Fader(4)” input ports 1/
2 by dragging and dropping.
Output port 1 of the “Matrix Mixer” will be used to send the Aux signal to the remote location. Output ports 2/3 of
the “Matrix Mixer” will be used to output to the speakers in the local location. Output port 4 of the “Matrix
Mixer” will be used as an input to the AEC reference.
7.
Connect the space between the “Matrix Mixer” output port and the “PEQ(4)” input port
1 by dragging and dropping.