User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
87
9.
Select “Building” on the [Environmental Sound] list box for source 1, and click the [ON]
button for source 1 to turn it on.
Set the environmental sound to “Building” (air-conditioner sound) to send speech privacy sounds through the hall-
way speakers.
10.
Click the [×] button at the top right-hand corner to close the component editor.
11.
Drag and drop from between the “Fader(4)” output ports 1 and 2 to the “YDIF OUT”
input ports 3 and 4 to connect them.
Now you’re finished placing and connecting the components. Change the placement of the components and change the wir-
ing as need be.