User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Basic MTX3 system example (analog connections)
- Example 2) High audio quality system with XMV and YDIF connections (digital connections)
- Example 3) Using cascade mode to add MTX input channels (analog connection)
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Setting the MCP1’s UNIT ID
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 4) A system using Dante
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Dante settings between systems
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 5) A system using the PGM1 for paging
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Power-on the PoE-equipped gigabit network switch
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 5) A system using the PGM1 for paging
MTX Setup Manual
150
Power-on the PoE-equipped gigabit network switch
The PGM1 starts.
Power-on equipment other than amps and powered speakers
Power-on equipment other than amps and powered speakers.
When powering-off equipment other than amps and powered speakers, start by powering-off the amps and powered speak-
ers.
Power-on amps and powered speakers
Power-on amps and powered speakers.
To prevent unwanted sound from being output, we recommend that you minimize the attenuator settings of all channels on
the amp or powered speaker itself before you turn it on.
Specifying the computer’s TCP/IP address
To allow the MTX and the computer to communicate, specify the computer’s TCP/IP as follows.
1.
On MTX-MRX Editor’s [System] menu, click [Network Setup].
The “Network Setup” dialog box will appear.
2.
Click [Open Network Connection].
“Network Connections” will appear.
3.
Right-click the adapter to which the MTX is connected, and choose [Properties].
The “Local Area Connection Properties” dialog box will appear.
4.
Choose [Internet Protocol Version 4 (TCP/IPv4)], and then click [Properties].
The “Internet Protocol Version 4 (TCP/IPv4) Properties” dialog box will appear.
5.
Click [Use the following IP address (S)].