User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Basic MTX3 system example (analog connections)
- Example 2) High audio quality system with XMV and YDIF connections (digital connections)
- Example 3) Using cascade mode to add MTX input channels (analog connection)
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Setting the MCP1’s UNIT ID
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 4) A system using Dante
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Dante settings between systems
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 5) A system using the PGM1 for paging
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Power-on the PoE-equipped gigabit network switch
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) Using cascade mode to add MTX input channels (analog connection)
MTX Setup Manual
73
MCP1 settings
Here we’ll assign functions to the MCP1 that is located at the chairman’s seat.
To make these settings, choose the [Controller] menu item [MCP1].
When you click one of the numbered buttons, a “Settings” dialog box will appear; assign parameters to the switch.
Click the [Label] button to open the “Label” dialog box. Here you can make settings for the MCP1’s display, to indicate
the role that each button will perform.
When you’ve made the assignments and display settings, click to select “01 [No data]” and then click the [Save] button.
In the “Save Library” dialog box, change the name to “Basic” and then click the [OK] button.
Assign the parameters. If you assigned [SD Song Select & Play], enter the name of the file that you want to play or the
name of the folder that contains the file you want to play.
L1 switch turns mute on/off for the microphone inputs other than the chairman’s seat. L2 switch turns the chairman’s
microphone on/off. L3 switch will access the screen for adjusting the input level from the chairman’s mic.