User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“EXo8” screen Chapter 4. System screen
MTX-MRX Editor User Guide
134
“EXo8” screen
Here you can view and edit the parameters of the EXo8 units in the MTX/MRX system. When you
right-click on the display area of a desired EXo8, a context menu appears, allowing you to copy and
paste settings between devices.
1 [EDIT] button
This enables the EXo8 input routing select buttons.
The [EDIT] button is available only in the offline state.
2 EXo8 identification area
Shows the UNIT ID, model type, and model name of the corresponding EXo8 unit.
3 Input routing select buttons
These buttons open the “EXo8 Patch” dialog box where you can select the audio signal
output source device and channels.
To enable these buttons, click the [EDIT] button.
4 Channel index
Indicates the channel number of the EXo8.
5 [ON] button
Switches the output channel on/off. The button also shows the on/off status.
6 POLARITY button
Switches the polarity of the output signal.
7 Attenuator
Shows the EXo output attenuator setting.
You can double-click this and edit it.
8 Channel name
Indicates the channel name. You can double-click this and edit it.
3
5
7
1
2
4
6
8
NOTE