User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Recall Filter setting screen Chapter 6. Presets
MTX-MRX Editor User Guide
158
■ [PASTE] button
Pastes the copied Recall Filter settings to the currently selected preset.
The Paste command is not available while online.
■ [Apply] button
Applies the currently-edited Recall Filter settings. If the settings have not been edited, this
button will be unavailable and cannot be clicked.
■ [Close] button
Closes the dialog box.
■ [MTX]/[MRX] tab
Here you can choose the MTX/MRX unit for which to make Recall Filter settings. The tab
shows the UNIT ID and device name.
● [All On] button
Turns on (blue) all of the buttons of the currently selected tab. All parameters will be
recalled.
● [All Off] button
Turns off (white) all of the buttons of the currently selected tab. None of the parameters
will be recalled.
● Parameter select buttons
For the MRX, only the [DCP] button and [Wireless DCP] button are shown.
• [HA] button
If this is on, the HA gain and phantom power (+48V) settings of the input ports will
be recalled.