User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Recall Filter setting screen Chapter 6. Presets
MTX-MRX Editor User Guide
162
■ [External I/O] tab
Here you can choose the external device parameters for which to make Recall Filter
settings.
● [All On] button
Turns on (blue) all of the buttons of the currently selected tab. All parameters will be
recalled.
● [All Off] button
Turns off (white) all of the buttons of the currently selected tab. None of the parameters
will be recalled.
● Parameter select buttons
The parameter select buttons are shown for each device (UNIT ID, device name). If
these buttons are on, the parameters included in the buttons will be recalled for each
channel. The [PWR] button corresponds to the power on/standby status of the device,
and the alphabetical or numeric buttons correspond to the channels of each device.
In the case of the R series (AD/DA) or Tio1608-D, turning the button on will recall the
HA parameters for each unit.