User Manual

List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
246
Switch settings
Select the following parameter types to be controlled by the switches, and then make
the appropriate settings.
•Input Ch Send On
•Input Ch Send Level
❍ [DEVICE]
Select the device that you want to change. These are shown in order of UNIT ID and
model name.
❍ [PARAMETER1]/[PARAMETER2]
In the [PARAMETER1] column, select the target ZONE.
For Input Ch Send On, click the ? at the left of the channel name in the
[PARAMETER2] column to select ON, OFF, or IGNORE for the desired channels.
“On” can be specified only for one channel.
For Input Ch Send Level, set the following parameters as well.
❍ [Inc]
If you select this option, pressing the switch each time will raise the level or the send
level.
✦[Upper Limit]
Specifies the maximum level achieved when you press the switch.
✦[Minimum]
If the current parameter value is lower than the value specified here, pressing the
switch once will set the parameter to this value.
❍ [Dec]
If you select this option, pressing the switch each time will lower the level or the send
level.
✦[Lower Limit]
Specifies the minimum level achieved when you press the switch.
✦[Mute Enable] check box
If this is on, the Mute state (–∞ dB) will be enabled if the level is lowered below the
value specified by [Lower Limit].
❍ [Switch]
Allows you to make switch-related settings.
[Sensitivity] specifies the sensitivity at which the parameter will change when the
switch is pressed.