User Manual

Menu bar Chapter 2. Menu bar and tool buttons
MTX-MRX Editor User Guide
30
[System]
[Network
Setup]
Selects the computer’s network adapter that will be
used to communicate with the MTX/MRX.
You can also change the IP address of the network
adapter.
“Network Setup”
dialog box
[Device
Information]
Lists the devices on the network, allowing you to
update their firmware and change their IP address.
“Device Information”
dialog box
Match Device
by IP Address
Makes settings for devices that are on a different
subnet than the computer.
“Match Device by IP
Address” dialog box
[Install Speech
Privacy File]
Transmits to the MRX a file used when using the
“Speech Privacy” component on the MRX.
For details, refer to “MRX Designer User Guide.”
“Install Speech Privacy
File” dialog box
[MTX
Configuration]
Here you can specify input/output settings for each
device, such as MTX input ports, output channels,
and matrix buses.
This command is not available in the Project screen.
“MTX Configuration”
dialog box
[Dante
Information]
Indicates the Dante settings and firmware version.
Here you can also make settings for bit rate and
latency.
“Dante Information”
dialog box
[Word Clock]
Specify the project’s word clock master and word
clock settings.
“Word Clock” dialog
box
[Clock]
Regardless of the online/offline state, the time and
date will be updated for all devices connected to the
same network.
“Clock” dialog box
[Daylight
Saving Time]
Regardless of the online/offline state, the daylight
saving time setting is specified for all devices
connected to the same network.
“Daylight Saving Time”
dialog box
[Scheduler]
Switches presets or plays back a song or sound
effect from an SD memory card at a previously
specified date and time. Each such setting is called
an “Event.” You can make event settings in the
“Scheduler” dialog box.
“Scheduler” dialog box
[GPI
Calibration]
Calibrates the input voltage detection range for the
[GPI] connector of the MTX/MRX unit. (Available
only when online.)
“GPI Calibration”
dialog box
[GPI] Makes GPI input/output settings. “GPI” dialog box
[Remote
Control]
Makes settings for the [RS-232C] connector.
“Remote Control”
dialog box
View
[Large Scale
View]
Sets MRX Designer’s component editor and MTX-
MRX Editor to a vertical and horizontal display
magnification of 200%.
–
Menu Command Summary
Dialog box that
appears