User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“PAGING” screen (MTX5-D only) Chapter 4. System screen
MTX-MRX Editor User Guide
93
5 GAIN setting area
Each knob resets to the default value if you click it while holding down the <Alt> key.
In this area, you can make settings related to the line shown in green in the flow
depicted below.
•[RANGE] knob
Specifies the Program value while the chime is sounding or while the PGM1 is
broadcasting.
•[ATTACK] knob
Specifies the time from when the PGM1’s PTT turns on until the program decreases
to the RANGE value.
•[RELEASE] knob
Specifies the time from when the broadcast or the closing chime finishes playing
until the program returns to its original level.
6 ZONE GROUP area
•Zone name
Indicates the zone name specified for the OUTPUT fader below.
•Group name
Indicates the group name. You can double-click this and edit it.
• ZONE GROUP matrix
Specify a zone group if you want a single zone/message select button of a PGM1/
PGX1 to broadcast to multiple zones. Click an intersection in the matrix to turn it
on/off. Zones that are colored green belong to a zone group. You can specify up to
24 zone groups.
Program Output
0dB
Mic/SD Output
–∞
ReleaseAttack
Range
Mic Input
time
level
SD Input
Opening
Chime
Closing
Chime
PTT : On PTT : Off