User Manual
MTX3/MTX5-D/XMV Series/EXi8/EXo8 Remote Control Protocol Specications V1.3.0
10
3. Command Specications
3.2.4. Event processing change notication
1-9) Media insertion notication
Command Option 1 Option 2 Description
NOTIFY event MTX:Media "sdcard=inserted" An SD memory card was inserted.
"sdcard=extracted" An SD memory card was removed.
Example: Notication: NOTIFY event MTX:Media "sdcard=inserted"
Meaning: An SD memory card was inserted into an SD memory card slot and was detected normally.
* SD Card should not be removed when the MTX is powered on.
1-10) Time synchronization notication <Old format>
Command Option 1 Option 2 Description
NOTIFY event MTX:AbsoluteTime "yyyy/mm/dd hh:mm:ss" Time synchronization notication
Details: yyyy = Year (Gregorian)
mm = Month (1 to 12)
dd = Day (1 to 31)
hh = Hour (0 to 23)
mm = Minute (0 to 59)
ss = Second (0 to 59)
* DST (Daylight Saving Time) is not accounted for.
Example: Notication: NOTIFY event MTX:AbsoluteTime "2013/1/25 10:58:19"
Meaning: The time was set to January 25, 2013, 10 hours 58 minutes 19 seconds.
Note: This command’s option1 string "MTX:AbsoluteTime" is retained to keep compatibility with previous programming using
the previous protocol. The command’s function is identical to the new format shown below.
Device sends both format commands when time is set in order to keep compatibility with program which done for old
format in past.
Ignore this command and process new format command in new program.
1-11) Time synchronization notication <New format>
Command Option 1 Option 2 Description
NOTIFY event MTX:SetAbsoluteTime "yyyy/mm/dd hh:mm:ss" Time synchronization notication
Details: yyyy = Year (Gregorian)
mm = Month (1 to 12)
dd = Day (1 to 31)
hh = Hour (0 to 23)
mm = Minute (0 to 59)
ss = Second (0 to 59)
* DST (Daylight Saving Time) is not accounted for.
Example: Notication: NOTIFY event MTX:SetAbsoluteTime "2013/1/25 10:58:19"
Meaning: The time was set to January 25, 2013, 10 hours 58 minutes 19 seconds
1-12) DST enable change notication
Command Option 1 Option 2 Description
NOTIFY event MTX:DSTSetEnable "enable" DST enable
"disable" DST disable
Example: Notication: NOTIFY event MTX:DSTSetEnable "enable"
Meaning: DST was enabled
1-13) DST offset time change notication
Command Option 1 Option 2 Description
NOTIFY event MTX:DSTSetOffset "offset=hh:mm" DST offset time change notication
Details: hh = Hour (0 to 2)
mm = Minute (0 to 59)
Example: Notication: NOTIFY event MTX:DSTSetOffset "01:00"
Meaning: DST offset was set one hour