User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
Selecting multiple components, ports, or wires
MRX Designer User Guide
21
❑ Selecting multiple components, ports, or wires
Here’s how to select multiple components placed in the design sheet, or multiple wires that connect
ports of components.
• Use the mouse cursor to completely enclose objects
Drag the mouse cursor to select the components, component ports, wires, and text
that are completely enclosed by the rectangular area in the design sheet.
If the selection encloses an expanded User Defined Block, and the point at which you
start dragging is on the style sheet, then the objects on the style sheet are selected. If
the point at which you start dragging is on a User Defined Block, then objects on the
User Defined Block are selected.
• Hold down <Ctrl> and use the mouse cursor to completely or partially enclose
objects
Hold down <Ctrl> and drag the mouse cursor to select the components, component
ports, wires, and text that are completely or partially enclosed by the rectangular
area in the design sheet.
If the selection encloses an expanded User Defined Block, and the point at which you
start dragging is on the style sheet, then the objects on the style sheet and the User
Defined Block are selected. If the point at which you start dragging is on a User
Defined Block, then objects on the User Defined Block are selected.
NOTE
NOTE